BOLEX H16 SBM Bedienungsanleitung PDF herunterladen (Seite 4)

MEDIA LOAN BOLEX H16 REFLEX BOLEX H16 REFLEX MEDIA LOAN

To set the diopter:

1. Turn the turret to expose the reex prism (no lens in the taking

position) or remove the cover of the bayonet mount.

2. Point the camera at a light source.

3. Unlock the diopter adjustment either by loosening the grooved

ring around the viewnder or the locking screw depending on

the camera model.

4. Adjust the viewnder until the grain of the ground glass is

perfectly sharp.

5. Lock the diopter nger tight, but DO NOT OVER-TIGHTEN.

tuRRet

By turning the turret, you can change from one lens to another. To turn the turret, use the

fold away lever rather than handling the lenses. In this way, there is less risk of accidentally

changing the aperture and/or focus ring – or damaging the lenses and/or camera. When using

heavier lenses, such as telephoto or zoom lenses, the turret should be locked with a turret

plug. Turret plugs go into the lowest lens cavity, when turret is in normal position, and most

are marked with a red ring. For lighter

lenses, the turret lock on the camera

should be sufcient for stabilizing the

turret. This lock is located above the

lens in the taking position and should

be tightened before the lenses are in

place. Place wide-angle lenses and the

telephoto lenses opposite of each other

on the turret so that the telephoto lens

does not interfere with the eld of the

wide-angle lens.

To attach a lens, simply unscrew the

turret cap and screw on the lens. You

can have up to three lenses mounted

at once on the turret mount. If using

less than three lenses, make sure turret

caps are secured in unused positions.

ALWAYS keep loose turret caps and

lens caps in the case to avoid losing

them.

tuRRet mount filteRs

Cameras with a turret mount have a lter between the taking lens position and the reex

prism. The lter remains in place no matter which lens is used. When lming without a lter,

an empty lter carrier should be left in the lter slot to prevent light from entering the camera

trough the slot and fogging the lm. Make sure the carrier is located rmly within the slot and

the correct lter is in place before shooting. An incorrect lter will either alter the color balance

or exposure.

Turret lever

Turret

lock

Filter

holder

Front release

button

Turret plug

Lens

taking

position

Bolex H-16 Rex turret.

Variable

shutter

1 2 3 4 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare

BOLEX H16 SBM Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern