BOLEX H16 SBM Bedienungsanleitung PDF herunterladen (Seite 5)

MEDIA LOAN BOLEX H16 REFLEX BOLEX H16 REFLEX MEDIA LOAN

BAyonet mount

The Bolex H-16 SBM camera has a single lens bayonet mount and is recommended for use with

heavier lenses. To mount a lens:

1. Turn the outer ring in the direction of the arrow (counter-clockwise if

camera is facing you). Press the button on the bottom of the mount

to move the screw into the open position where you will se the tabs

of the cap.

2. Lift the cap out of the mount and immediately place the lens mount

in its place. Be careful not to touch the prism!

3. Turn the ring clockwise to secure the lens mount in place and screw

the lens into place.

To remove a lens and secure the bayonet mount:

4. Unscrew the lens; replace lens caps and return to lens case.

5. Turn outer ring as described above until tabs in lens ring are revealed.

6. To remove the lens mount, tip camera forward with hand cupped

under below to catch the lens mount. DO NOT touch prism with

ngers!

7. Replace cap and secure by turning lens clockwise.

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

BOLEX H16 SBM Bedienungsanleitung Seite 5